Compass 4WD L4-2.4L VIN W (2007)
snapping it into place over the retaining tabs.
3. Install the ignition module (2) mounting screw (1). Tighten the screw to 2 Nm (18 in. lbs.).
NOTE: Ignition module needs to be installed on lock cylinder housing before housing installation to clear tilt lever.
4. Position the lock cylinder housing in the RUN position.
5. Align the lock cylinder housing (2) with the steering column.
6. Install the two screws (1) fastening the lock cylinder housing (2) to the column. Tighten the screws to 12 Nm (110 in. lbs.).
7. Place the actuator in the lock cylinder housing to the RUN position (if not already there).
