Compass 4WD L4-2.4L VIN W (2007)
NOTE: All seat belt retractors except the driver side front retractor include a switchable automatic locking mechanism.
1. Position the second row seat belt and retractor (7) to the lower inner C-pillar (6).
2. Engage the locator tab on the back of the retractor into the slot in the lower C-pillar.
3. Install and tighten the screw (5) that secures the retractor to the lower C-pillar. Tighten the screw to 40 Nm (30 ft. lbs.).
4. Position the seat belt turning loop to the upper C-pillar. Be certain the seat belt webbing between the retractor and the turning loop is not twisted.
5. Install and tighten the screw (1) that secures the turning loop to the upper C-pillar. Tighten the screw to 40 Nm (30 ft. lbs.).
6. Reinstall the trim onto the front of the quarter inner panel.
7. Route the seat belt lower anchor through the seat belt opening in the upper C-pillar trim (2).
8. Reinstall the upper trim onto the inside of the C-pillar.
9. Position the seat belt lower anchor to the rear floor panel (3). Be certain the seat belt webbing between the turning loop and the lower anchor is not
twisted.
10. Install and tighten the screw (4) that secures the lower anchor to the rear floor panel. Tighten the screw to 58 Nm (43 ft. lbs.).
11. Reinstall the rear seat cushion into the vehicle.
