Compass 4WD L4-2.4L VIN W (2007)
Parking Brake Warning Switch: Service and Repair
Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the console from the floor panel transmission tunnel (3).
3. Pull the parking brake lever (1) upward to apply the parking brake.
4. Disconnect the instrument panel wire harness connector from the terminal of the park brake switch (4) located on the inboard side of the park
brake lever mechanism.
5. Remove the screw (5) that secures the switch to the park brake lever bracket.
6. Remove the switch from the park brake lever bracket.
