Compass 4WD L4-2.4L VIN W (2007)
NOTE: Prior to attaching the outer tie rod end to the knuckle, inspect the tie rod seal boot. If the seal boot is damaged, replace the outer
tie rod end.
17. On each side of the gear, install the outer tie rod end (4) into the hole in the knuckle arm (3). Start a NEW tie rod mounting nut (2) onto the stud.
While holding the tie rod end stud with a wrench, tighten the nut with a wrench or crowfoot wrench. Tighten the nut to 132 Nm (97 ft. lbs.).
18. On each side of the vehicle, install the tire and wheel assembly (1). Install and tighten the wheel mounting nuts (3) to 135 Nm (100 ft. lbs.).
19. Lower the vehicle.
