Compass 4WD L4-2.4L VIN W (2007)
Suspension Strut / Shock Absorber: Testing and Inspection
Front Suspension
STRUT ASSEMBLY
Inspect the strut assembly for the following conditions:
-
Inspect for a damaged or broken coil spring (5).
-
Inspect for a torn or damaged dust shield (6).
-
Lift the dust shield and inspect the strut assembly for evidence of fluid running from the upper end of the strut fluid reservoir. (Actual leakage will
be a stream of fluid running down the side and dripping off lower end of unit). A slight amount of seepage between the strut shaft and strut shaft
seal is not unusual and does not affect performance of the strut assembly.
-
Inspect the jounce bumper for signs of damage or deterioration.
-
Inspect the clearance between the shock tower and the coil spring. Make sure no fasteners are protruding through the shock tower possibly
contacting the coil spring and strut. Because of the minimum clearance in this area, installation of metal fasteners could damage the coil spring
coating and lead to a corrosion failure of the spring.
CAUTION: At no time when servicing a vehicle can a sheet metal screw, bolt or other metal fastener be installed into the strut tower (1) to take
the place of an original plastic clip. Also, do not drill holes into the front strut tower for the installation of any metal fasteners into the shock
