Compass 4WD L4-2.4L VIN W (2007)
4. Place the Fixture (3) with knuckle in an arbor press.
5. Position Remover/Installer, Special Tool 9712-2 (2), in the small end of the hub. Lower the arbor press ram (1) and remove the hub from the
wheel bearing and knuckle. The bearing race will normally come out of the wheel bearing with the hub as it is pressed out of the bearing.
6. Remove the knuckle from the Fixture and turn it over.
7. Remove the snap ring (2) from the knuckle using an appropriate pair of snap ring pliers (1).
8. Place the knuckle back in the Fixture (3) in the arbor press ram.
9. Place Installer (2), Special Tool MD-998334, on the outer race of the wheel bearing. Lower the arbor press ram (1) and remove the wheel bearing
from the knuckle.
10. Remove the knuckle and tools from arbor press.
