Compass 4WD L4-2.4L VIN W (2007)
5. Remove large circlip (3) from the interconnecting shaft (2) before attempting to remove outer CV joint sealing boot.
6. Slide sealing boot off interconnecting shaft.
7. Thoroughly clean and inspect outer CV joint assembly and interconnecting joint for any signs of excessive wear. If any parts show signs of
excessive wear, the halfshaft assembly will require replacement. Component parts of these halfshaft assemblies are not serviceable.
Installation
INSTALLATION
1. Slide new sealing boot clamp (2) onto interconnecting shaft (4). Slide the outer CV joint assembly sealing boot (1) onto the interconnecting shaft
(4). Seal boot MUST be positioned on interconnecting shaft so the raised bead on the inside of the seal boot is in groove on
interconnecting shaft.
