Compass 4WD L4-2.4L VIN W (2007)
5. Position windshield (1) in center of windshield opening and resting on the side and lower spacers (2 & 3).
6. Adjust the lower spacers (3) as required, to obtain the specified roof gap tolerance by pushing on the side of the wedge and raising or lowering the
glass as necessary. For roof gap specifications, refer to the table Roof Gap Tolerances.
±±±±
7. Apply adhesive tape (1) to the locations shown to aid with final installation.
8. Verify windshield gap is parallel to with windshield.
9. Cut tape with a sharp knife and remove windshield.
