Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
Driver/Vehicle Information Display: Description and Operation
General Information
General Information
A multi-colored vacuum fluorescent (VF) display screen and vehicle outline. The VIC will perform four functions with the use of the SELECT and
SET buttons:
-
Display time and date (clock/calendar feature)
-
Monitor specific vehicle operating systems
-
Display service reminder or distance to service
-
Display 4wd transfer case modes of operation
Clock/Calendar Display
The clock/calendar display consists of:
-
Time (hours and minutes with AM and PM)
-
Day of the week (Monday through Sunday)
-
Date (Month and Day)
Monitored Systems
The vehicle systems monitored by the VIC are:
-
Right front door ajar
-
Left front door ajar
-
Right rear door ajar
-
Left rear door ajar
-
Liftgate open
-
Tail lamps
-
Engine oil level/sensor
-
Windshield washer fluid level/sensor
-
Engine coolant fluid level/sensor
-
Turn signal on
-
Electrical system voltage
-
Four/two wheel drive states
Service Reminders
There are two service reminders:
-
PERFORM SERVICE
-
MILES (KM) TO SERVICE
Four Wheel Drive Display
The VIC will illuminate the vehicle outline and telltale indicator lights exactly the same as the 4WD Graphic Display Module.
-
Rear wheels illuminated (2WD)
-
Front wheels illuminated (4WD)
-
PART TIME (Part Time 4WD)
-
FULL TIME (Full Time 4WD)
-
LO (Low Range 4WD)
When the ignition switch is turned ON, the module will display the distance-to-service message for 6 seconds. If the distance remaining to service is
zero, the module will instead display the 0 MILES TO SERVICE message for 11 seconds. Then the TONE-OUT line will pulse low for 6 sequences
of warning beeps. The 0 MILES TO SERVICE message will continue for an additional 2 seconds.
Next, if no monitored system faults exist and the time/date has been previously set, the module will display the current time and date. If a service fault
exists, the module will begin to display the fault message. If more than one message has to be displayed, the module will display up to 2 messages.
Then the clock function will pulse (unless a door is open and vehicle is at critical speed) in a continuous sequence at 3 second intervals.