jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Outside Door Handle Button - Inoperative|Page 6478 > < Outside Door Handle Button - Inoperative|Page 6476
Page 7
background image

Figure 1., Striker

2.

Slowly close the door until the striker loop contacts the latch (See Figure 1). Mark the location where the rearward side of the latch rachet contacts
the striker loop. Open the door and measure the clearance as shown in Figure 1. The clearance should be from 8 to 10 mm. (5/16 to 3/8 in.). If the
proper clearance is not attained shim adjustment is required. The chart in Figure 1 has been provided to show the thickness of the various shim
combinations.

NOTE

DO NOT EXCEED THE MAXIMUM SHIM THICKNESS SPECIFIED IN THE CHART. THE COMBINATION OF 1 GOLD AND 1 SILVER
SHIM IS THE MAXIMUM THICKNESS ALLOWED FOR PROPER THREAD ENGAGEMENT. DO NOT USE TWO GOLD SHIMS OR USE
MORE THAN TWO SHIMS IN COMBINATION.

3.

Loosen the striker screws and add or subtract shims using the chart to obtain the correct latch to striker contact.

4.

Align the striker height centering the striker in the latch opening as shown in Figure 2 and position it inboard or outboard to make the door flush,

5.

Tighten the screws to 30 Nm (250 in.lbs.).

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE: Latch Lock, Rt. Front Door - Replace (Inc. Adjustment)
Labor Operation No:

23-41-02-90

0.5 Hrs.

Latch Lock, Lt. Front Door - Replace (Inc. Adjustment)
23-41-02-91

0.5 Hrs.

Latch Lock, Rt. Rear Door - Replace (Inc. Adjustment)
23-41-02-92

0.5 Hrs.

Latch Lock, Lt. Rear Door - Replace (Inc. Adjustment)
23-41-02-93

0.5 Hrs.

Striker, Door Latch - Adjustment Only
23-41-02-94

0.2 Hrs.

FAILURE CODE:

P8 - New Part

Technical Service Bulletin # 230992

Date: 920601

Outside Door Handle Button - Inoperative

NO.:

23-09-92

GROUP:

Body

DATE:

Jun. 1, 1992

SUBJECT:
Outside Door Handle Button Inoperative

MODELS:

1993 (ZJ) Grand Cherokee

SYMPTOM/CONDITION:

The outside door handle button may be inoperative due to a binding condition in the door latch rods. The operation of the door lock cylinders or keyless
entry system could also be affected by the same condition. The source of the binding condition may be one of the following:

Outside Door Handle Button - Inoperative|Page 6478 > < Outside Door Handle Button - Inoperative|Page 6476