Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
Cargo Cover: All Technical Service Bulletins
Rear Cargo Cover - Jams/Fails To Rewind
NO.: 23-44-93
GROUP: Body
DATE: Aug. 6, 1993
SUBJECT:
Rear Cargo Cover Service
MODELS:
1993
(ZJ) Grand Cherokee/Grand Wagoneer
DISCUSSION:
The cargo cover may jam or fail to rewind. This may be caused by operating the cover after it has been installed upside down. The cover must be
installed with the opening facing the rear of the vehicle. If the cover is installed with the opening facing the rear seat, it may bind and the fabric may
bunch up. If this happens, a procedure has been developed to release the spring tension and rewind the mechanism. A label has also been released to aid
owners in installing the cover.
PARTS REQUIRED:
1
Label
4762327
REPAIR PROCEDURE:
This bulletin involves rewinding the cargo cover and installing label to aid the owner with correct installation of the cover.
1.
Remove the cargo cover from the vehicle.
2.
Completely unwind all of the material from the drum.
3.
Slide the cover material in the slot in the drum enough to clear the plastic sleeve.
4.
Compress the spring loaded release mechanism by standing the assembly on end with the plastic sleeve at the top and pushing down on the
assembly. This will cause the plastic sleeve to rotate as the spring tension is released. Make sure that all of the spring tension is released.
5.
Raise the assembly off the ground to lock the release mechanism. Wind the plastic sleeve in a counter clockwise direction 20 turns to reset the
spring.
6.
Slide the material in the slot on the drum to center the material.
7.
Install the assembly in the car with the opening in the sleeve facing rearward while keeping tension on the material to prevent it from winding onto
