Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
1. Position the actuator on the heater-A/C unit. Install and tighten the screws.
2. Connect the rod and rod clip to the door lever.
3. Connect the electrical connector.
4. Install the instrument panel. Refer to Body and Frame/ Interior Trim/ Dashboard/Instrument Panel/ Servive and Repair for the procedures.
See: Body and Frame/Interior Moulding / Trim/Dash Panel/Service and Repair
Removal
1. Remove the instrument panel. Refer to Body and Frame/ Interior Trim/ Dashboard/Instrument Panel/ Servive and Repair for the procedures.
See: Body and Frame/Interior Moulding / Trim/Dash Panel/Service and Repair
Fig.17 Recirculating Air Door Actuator (Heater And Manual A/C)
2. Disconnect the vacuum line.
3. Disconnect the actuating rod clip.
4. Remove the actuator retaining screws.
5. Remove the actuator.
Installation
