Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
Combination Switch: Service and Repair
1. Disarm airbag system as described under ``Airbag System Disarming.''
2. Remove tilt lever, if equipped.
3. Remove upper and lower steering column covers, then six screws holding knee bolster.
4. Remove steering column retaining nuts, then lower steering column to gain access to rear of multi-function switch.
5. Remove multi-function switch tamper proof mounting screws.
6. Carefully pull switch away from column, then loosen connector screw. Screw will remain in the connector.
7. Remove wiring connector, then the multi-function switch.
8. Reverse procedure to install. After installation, Rearm airbag system as outlined under ``Airbag System Disarming'' before connecting battery
ground cable.
