Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
6.
Install insulator, wedge and seal supplied in the jumper harness package onto the engine primary coil wires (Figure 2).
CAUTION:
Make sure proper coil polarity is maintained. Insert the gray/white (B-) wire into the insulator cavity that will connect to the gray/white wire
on the supplied jumper harness. Insert the dark green/black (B+) wire into the insulator cavity that will connect to the pink resistor wire on
the supplied jumper harness.
7.
Connect the supplied jumper harness to the ignition coil and primary coil wiring (on engine harness). Loop the jumper harness toward the
battery and secure it to the battery harness in three locations using the attached tie straps.
CAUTION:
Make sure jumper harness is away from all sharp edges and moving parts.
8.
Connect the negative battery cable.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record service
completions and provide dealer payments.
Use one of the labor operation numbers and time allowances (see illustration).
Add the cost of the parts package plus applicable dealer allowance to your claim.
Note:
See Warranty Policy and Procedure Manual, Chapter 6, Subsection H for complete claim processing instructions.
Parts Return
Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation 429-10-04
P.O. Box 1919
Detroit, Michigan 48231-1919
Following the above procedures will expedite the processing of your claim.
