Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
Front Door Window Glass Weatherstrip: Service and Repair
DOOR WINDOW GLASS AND DOOR OPENING SEALS
The window glass seals can be removed by hand. The door opening seal is attached to edge of door opening in body The front door secondary seal
is attached to A-pillar.
WINDOW GLASS SEAL INSTALLATION
When installing front or rear door window glass weatherstrip seals, open window completely.
1. To install a front door window channel weatherstrip seal, start at upper, rear corner.
2. To install a rear door window glass channel weatherstrip seal, start at upper, front corner.
3. Install seal evenly until it is fully seated in channel.
4. Position belt weatherstrip seals at window edge. Force them downward until seated on flange.
DOOR OPENING WEATHERSTRIP SEAL INSTALLATION
1. When installing a door opening weatherstrip seal, start at rear of front seal and front of rear seal using paint dots as location points.
2. Use adhesive along with push-studs to aid in retaining a weatherstrip seal.
3. Move upward and around edge of door opening. Seat seal on flange.
LIFTGATE OPENING WEATHERSTRIP SEAL REMOVAL
1. Pull seal away from flange around edge of liftgate opening. Remove it from vehicle.
2. Clean seal flange as necessary
INSTALLATION
1. Position weatherstrip seal in opening with left end of seal at opening centerline. Install seal in a clockwise direction.
2. Seat installed part of seal. Move from left bottom end of seal to top left half of the seal.
3. Center and butt seal ends together at centerline.
