Grand Cherokee 2WD L6-242 4.0L VIN S MFI (1993)
5. Separate flip-up glass from vehicle.
DISASSEMBLY
1. Remove ball studs from glass panel.
2. Remove hinge from glass panel.
3. Remove handle/striker.
ASSEMBLY
1. Install ball studs onto glass panel. Tighten screws to 6 Nm (60 in. lbs.).
2. Position hinges on to glass panel and finger tighten screws.
3. Install handle/striker. Tighten screws to 6 Nm (60 in. lbs.).
INSTALLATION
1. Position flip-up glass on liftgate.
2. Install hinge nuts. Tighten nuts to 6 Nm (60 in. lbs.).
3. Check alignment of glass panel. If panel is aligned correctly, tighten hinge screw to 6 Nm (60 in. lbs.).
4. Install prop rods onto ball studs and compress locking caps to lock prop rods onto ball studs.
LIFTGATE FLIP-UP GLASS LATCH/LOCK COMPONENTS REMOVAL
1. Raise liftgate. Remove liftgate trim panel. If necessary refer to service procedure.
Flip-Up Glass Latch/Lock Component
2. Remove latch nuts.
3. Disconnect switch connector.
4. Remove latch from liftgate.
INSTALLATION
1. Position latch on vehicle 2.5 mm forward of seal.
2. Connect switch connector.
3. Install latch nuts. Tighten to 11 Nm (100 in. lbs.).
4. Close flip-up glass panel and verify proper operation.
5. Install liftgate trim panel.
FLIP-UP GLASS SWITCH REMOVAL
1. Remove liftgate trim panel.