Grand Cherokee 2WD L6-4.0L VIN S (1997)
Body Control Module Remove/Install
(2) Remove the four screws securing the body control module to the instrument panel armature.
(3) Move the body control module towards the steering column far enough to unplug the three wiring connectors.
(4) Remove the body control module.
(5) Reverse the removal procedures to instal~.
Glove Box Module
GLOVE BOX MODULE
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
(1) Remove the knee blocker/steering column cover as described.
(2) Remove the two screws securing the top of the instrument panel center bezel above the graphic display module/vehicle information center.
(3) Remove the ash receiver and remove the two screws in the back of the ash receiver opening of the center bezel.
(4) Remove the courtesy lamp under the right end of the instrument panel.
(5) Open the right front door and remove the screw in the right end of the instrument panel.
(6) Remove the four screws in the glove box hinge on the bottom edge of the lower right instrument panel module.
(7) Open the glove box door and remove the four screws on the upper edge of the glove box opening in the lower right instrument panel module.
(8) Lower the lower right instrument panel far enough to unplug the wiring connectors for the glove box lamp/switch, the cigar lighter/lamp, and the
power outlet. Also remove the bulb and socket as a unit from the ash receiver lamp hood.
(9) Remove the lower right instrument panel module from the vehicle.
(10) Reverse the removal procedures to install.
