jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Instrument Panel|Page 7712 > < Circuit Operation|Page 7709
Page 1
background image

Speaker: Service and Repair
Instrument Panel

WARNING:  ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.

Cowl Top Trim Remove/Install

2. Using a wide flat-bladed tool such as a trim stick, pry the cowl top trim panel off of the instrument panel top pad.
3. Pull the panel up far enough to unplug the wire harness connector for the solar sensor, or to remove the solar sensor from the cowl top trim, if the

vehicle is so equipped.

4. Remove the cowl top trim panel from the vehicle.
5. Unplug the speaker wire harness connector.

Instrument Panel Speaker Remove/Install

6. Remove the two screws that secure the speaker to the instrument panel.
7. Remove the speaker from the instrument panel.
8. Reverse the removal procedures to install.

Instrument Panel|Page 7712 > < Circuit Operation|Page 7709