Grand Cherokee 2WD L6-4.0L VIN S (1997)
Power Seat Switch: Service and Repair
Power Seat Switch
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick or other suitable wide flat bladed tool, gently pry the power seat and power recliner switch knobs off of the switch stems.
3. Remove the three screws that secure the seat cushion side shield to the seat cushion frame.
4. Pull the side shield away from the seat cushion far enough to unplug the switch wire harness connector.
Power Seat Switches Remove/Install
5. Remove the two screws that secure the switch to the inside of the side shield.
6. Remove the switch from the side shield.
7. Reverse the removal procedures to install.
