Grand Cherokee 2WD L6-4.0L VIN S (1997)
Wheel Speed Sensor: Service and Repair
Front
REMOVAL
1. Turn ignition switch to OFF position.
2. Raise vehicle.
3. Remove wheel and tire assembly.
Front Wheel Speed Sensor
4. Remove bolt attaching front sensor to steering knuckle.
5. Disengage sensor wire from brackets on steering knuckle and frame member.
6. Unseat grommet that secures sensor wire in fender panel.
7. In engine compartment, disconnect sensor wire connector at harness plug.
8. Remove sensor and wire assembly.
INSTALLATION
1. Apply Mopar Lock N' Seal or Loctite 242 to sensor attaching bolt. Use new sensor bolt if original bolt is worn or damaged.
