Grand Cherokee 2WD L6-4.0L VIN S (1997)
Seal Installation
6. Seat dust boot in caliper either by hand, or with a suitable size installer tool.
7. Press caliper to bottom of bore after seating dust boot. Be sure to use wood block to protect piston and boot.
8. Install caliper bleed screw, if removed.
9. Install bushing and boot assemblies in caliper. Be sure boots are centered in caliper as shown.
10. Apply silicone grease to interior of bushing boots. Then apply same lubricant to exterior and interior of bushings.
11. Install mounting bolt bushings in boots. Be sure boot lips are seated in grooves at ends of bushings.
12. Center bushing boots in caliper.
13. Install brake shoes in caliper.
14. Install caliper.
