Grand Cherokee 2WD L6-4.0L VIN S (1997)
1. Raise vehicle and remove tire and wheel assemblies.
2. Press caliper piston into caliper bore with C-clamp.
Fig. 8 Rear Caliper Mounting Bolts
3. Remove caliper mounting bolts.
4. Rotate caliper rearward by hand or with pry tool. Then rotate caliper and brake shoes off ledges of mounting bracket.
5. Remove caliper fitting bolt and disconnect rear brake hose at caliper. Discard metal washers on fitting bolt. Washers should be replaced and not
reused.
6. Remove caliper from vehicle.
INSTALLATION
1. Verify that brake shoes are correctly positioned in caliper.
2. Position caliper over rotor and into bracket. Be sure brake shoe tabs are properly seated on mounting bracket ledges.
3. Connect rear brake hose to caliper. Use new washers on hose fitting and tighten hose fitting bolt to 24-38 Nm (18-28 ft. lbs.).
4. Check brake hose position before proceeding. Verify that hose is not twisted, kinked, or touching any suspension components.
