jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Service Procedures|Page 8931 > < Service Procedures|Page 8929
Page 12
background image

Glove Box Lamp And Switch Remove/Install

(2) From the back side of the lower right instrument panel module, squeeze the retaining tabs on the glove box lamp and switch housing together and

push the unit out through the front of the mounting hole in the module.

(3) To install the glove box lamp and switch unit, insert the unit through the mounting hole from the front of the lower right instrument panel module and

push in on the unit firmly until the retaining tabs snap into place.

Glove Box Latch Striker

GLOVE BOX LATCH STRIKER

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

(1) Remove the lower right instrument panel module as described.

Glove Box Latch Striker Remove/Install

(2) From the top of the lower right instrument panel module, straighten the two mounting tabs.

(3) Remove the latch striker from the upper glove box opening.

(4) To install the latch striker, insert the mounting tabs through the slots in the upper glove box opening and bend the tabs over from the top of the lower

right instrument panel module.

Cigar Lighter

CIGAR LIGHTER

Service Procedures|Page 8931 > < Service Procedures|Page 8929