Grand Cherokee 2WD L6-4.0L VIN S (1997)
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
(1) Disconnect and isolate the battery negative cable.
(2) Remove the switch pod bezels, the cluster bezel, the knee blocker, the lower right instrument panel module, and the cowl top trim panel as described.
(3) If so equipped, remove the auto headlamp light sensor/vehicle theft security system lamp mounting screw near the left defroster duct outlet and move
it for clearance of the instrument panel top pad.
(4) Remove all of the screws around the perimeter of the instrument panel top pad, which secure the top pad to the instrument panel armature.
(5) Lift the top pad off of the instrument panel armature and remove it from the vehicle.
(6) Reverse the removal procedures to install.
Instrument Panel Center Bezel
INSTRUMENT PANEL CENTER BEZEL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
(1) Remove the lower right instrument panel module as described.
Center Bezel Remove/Install
(2) From the rear of the lower right instrument panel module, remove the two screws securing the center bezel to the lower right module.
(3) Reverse the removal procedures to install.
Junction Block
JUNCTION BLOCK
