Grand Cherokee 2WD L6-4.0L VIN S (1997)
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner
Notification Form or describe the reason on a postcard and mail to:
Chrysler Corporation
CIMS 482-00-85
800 Chrysler Drive East
Auburn Hills, Michigan 48326-2757
Following the above procedures will expedite the processing of your claim.
If you have any questions or need assistance in completing this action, please contact your Zone Service Office.
Service Procedure For Cherokee/Grand Cherokee (XJ/Zj) Vehicles
WARNING:
The fuel system is under constant fuel pressure even with the engine off. Fuel pressure must be released before servicing the fuel tank.
1.
With the ignition key in the OFF position, disconnect the battery.
Note:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.
2.
Remove the fuel tank filler cap to release the fuel tank pressure.
3.
Remove the protective cap from the pressure test port on the fuel rail.
WARNING:
Do not allow fuel to spill onto the engine intake or exhaust manifolds. Place shop towels under and around the pressure port to absorb fuel when
pressure is released from the rail.
4.
Obtain the hose from the fuel pressure gauge tool set # 5069. Position one end of the hose into an approved gasoline container, then attach the
hose to the fuel rail test port to release the fuel pressure.
5.
Remove the hose from the fuel rail and reinstall the test port cap.
6.
Raise the vehicle on an appropriate hoist.
7.
For XJ vehicles only: Remove the fuel hose shield (Figure 1).
