Grand Cherokee 2WD L6-4.0L VIN S (1997)
level.
On transition from "run" to "start" a bulb-check feature is performed. This consists of activating all CCD controlled indicator lamps, the ABS
lamp, and all VF display segments for approximately 2-4 seconds.
Memory System Description
MEMORY SYSTEM
An optional memory system is available. The memory features include a 10 position driver's seat, outside mirrors, and radio presets. Up to two
different memory settings are available. Either memory profile can be selected via the door mounted memory select switches or the keyless entry
transmitter. The radio will allow 10 AM and 10 FM presets to be stored for driver 1 and the same for driver 2. If driver 1 enters the vehicle with
the Remote Keyless Entry (RKE) or pushes the memory switch 1, then decides to listen to driver 2 radio stations, this can be accomplished by
pushing the memory switch 2 when the vehicle is above 15 MPH. This will select driver 2 radio stations but will leave mirror and seat position
unaffected. If the entire memory system is inoperative, see Memory Seat Test 1A.
Memory Seat
MEMORY SEAT
This optional feature allows up to two different driver seat positions to be set and automatically recalled upon demand. The seat can be
repositioned to position 1 or 2 via the remote keyless entry transmitter or the door mounted memory switches. The set procedures are as follows:
1) Move the seat to desired location. 2) Depress the Memory Set switch. An indicator on the Set switch will illuminate and flash to indicate the
system is in the set mode. 3) Depress either the 1 or 2 switch. The flashing Set indicator will go out to indicate that the set has been achieved. A
CCD message is sent to the Memory Seat Module identifying current seat position as memory set 1 or 2 (via seat position potentiometer values).
To recall established Set Positions: Either unlock the doors via the remote keyless entry transmitter or push a memory switch button. The door
module recognizes the transmitter as being either #1 or #2 and sends a CCD message to the Memory Seat Module asking for the seat to be moved
to the position established for #1 or #2. If during a Memory Recall cycle, the driver attempts to move the seat, the Memory Recall function is
aborted and the seat will move to the desired location. Memory recall will be inhibited when either the driver's seat belt is buckled, or the vehicle
is in motion (15 mph). Also pulling the belt out of the retractor will stop the memory seat.
Heated seats are optionally available. A relay module located under each front seat controls the heat level based on I/P mounted switch. Two
levels of heat are available (low and high).
Radio Systems Description
RADIO SYSTEMS
There are 4 radio systems available in the Grand Cherokee. The sales codes for the radios are:
RAS - AM/FM cassette, two band E.Q., no external amplifier
RAS - AM/FM cassette, two band E.Q., no external amplifier, no CCD diagnostics.
RBR - AM/FM CD, 3 band E.Q., external amplifier
RBR - AM/FM CD, 3 band E.Q., external amplifier, CCD diagnostics.
