Grand Cherokee 2WD L6-4.0L VIN S (1997)
12.
Hook the spring rod through the detent lever (Figure 5).
NOTE:
The spring rod must be oriented through the detent lever as shown in Figure 5.
13.
Install the detent lever pivot base over the rear shifter mounting stud (Figure 5).
14.
Install the rear floor shifter mounting nut onto the stud and tighten to 220 in-lbs. (24 N.m).
15.
Verify that the detent lever is positioned (centered) directly over the shifter yoke collar detent roller (Figure 6).
16.
Cycle the shifter lever from reverse "R" to "1" and then to the park "P" position.
17.
Place the ignition key in the "LOCK" position and verify that the key can be removed from the lock cylinder.
