Grand Cherokee 2WD L6-4.0L VIN S (1997)
additional 0.56 Nm (5 inch lbs.).
6. If the rotating torque is low, use Holder 6958, or equivalent to hold the pinion yoke, and tighten the pinion shaft nut in 6.8 Nm (60 inch lbs.)
increments until the proper rotating torque is achieved.
CAUTION: If the maximum tightening torque is reached prior to reaching the required rotating torque, the collapsible spacer may have been
damaged. Replace the collapsible spacer.
7. Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft.
8. Add gear lubricant to the differential housing if necessary.
9. Install the brake drums.
10. Install wheel and tire assemblies.
11. Lower the vehicle.
