jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Power Window Control Module > < Heated Glass Element Relay|Description and Operation|Page 10217
Page 1
background image

Heated Glass Element Relay: Service and Repair

WARNING:  ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. Remove the fuse access panel by unsnapping it from the right cowl side trim panel.

Right Cowl Side Trim Panel Remove/Install

3. Remove the push nut that secures the right cowl side trim to the junction block stud.
4. Remove the two screws that secure the right cowl side trim panel to the right front door opening trim.
5. Remove the right cowl side trim panel.
6. Unplug the defogger - relay from the junction block.
7. Install the defogger relay by aligning the relay terminals with the cavities in the junction block and pushing the relay firmly into place.
8. Connect the battery negative cable.
9. Test the defogger relay operation.

10. Install the right cowl side trim panel and the fuse access panel.

Power Window Control Module > < Heated Glass Element Relay|Description and Operation|Page 10217