Grand Cherokee 2WD V6-3.7L (2008)
1. Position the power sunroof motor/module (1) in the vehicle.
2. Install the motor/module retaining screws (3). Tighten the screws to 4 Nm (35 in. lbs.).
3. Connect the motor/module electrical connector (2).
4. Partially install the vehicle headliner and connect all remaining sunroof electrical connectors, See: Interior Moulding / Trim/Headliner/Service and
Repair/Headliner - Installation.
5. Connect the battery negative cable.
6. Perform the sunroof position calibration, See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration.
7. Perform the Motor/Module Initialization Procedure, See: Testing and Inspection/Programming and Relearning.
8. Complete the vehicle headliner installation, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Installation.
9. Verify proper operation of the power sunroof system.
