Grand Cherokee 2WD V6-3.7L (2008)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor - Installation
INSTALLATION
1. Reconnect the wheel speed sensor wire connector (1).
2. Reroute and connect the wheel speed sensor wire to the routing clips (2).
3. Install the wheel speed sensor into the hub (3) and then install the mounting bolt (2) and tighten the nut to 12-14 Nm (106-124 in. lbs.).
4. Check the sensor wire routing (1). Be sure the wire is clear of all chassis components and is not twisted or kinked at any spot.
5. Install the disc brake rotor See: Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Installation.
6. Install the caliper adaptor over the rotor.
7. Install the caliper adaptor bolts and tighten to 90-115 Nm (66-85 ft. lbs.) See: Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Disc Brake Caliper - Installation.
8. Install the tire and wheel assembly.
9. Remove the support and lower vehicle.
