Grand Cherokee 2WD V6-3.7L (2008)
4.
Remove and discard the brake hose banjo bolt and copper washers (Figure 2).
5.
Push the caliper pistons slightly into the caliper by using a C-clamp.
6.
Remove the brake caliper slide pin bolts (Figure 2).
7.
Remove the brake caliper from the brake adapter (Figure 3).
8.
Destroy the old caliper so that it cannot be reused and discard.
9.
Install the new caliper on the adapter.
10.
Install the caliper slide pin bolts and tighten to 32 ft.lbs. (44 N.m) (Figure 2).
11.
Gently lift one end of the slide pin bolt boot to equalize air pressure, then release the boot and verify that the boot is fully covering the slide pin.
12.
Attach the brake hose to caliper using the new banjo bolt and one new copper washer on each side of the hose block.
Tighten the banjo bolt to 23 ft. lbs. (31 N.m).
CAUTION:
Verify brake hose is not twisted or kinked before tightening the banjo bolt.
13.
Repeat steps 3 through 12 on the other caliper if it requires replacement.
