Grand Cherokee 2WD V6-3.7L (2008)
14.
Lower the vehicle from the hoist and remove the brake pedal prop rod.
15.
Bleed the brake system using the following procedure:
a.
Fill the brake master cylinder reservoir with DOT 3 brake fluid.
b.
Attach one end of bleed hose to bleed screw on the brake caliper and insert opposite end in a clear container partially filled with brake fluid
(Figure 4).
Be sure that the end of bleed hose is immersed in brake fluid.
c.
Open the bleeder screw on the brake caliper, then have an assistant press and hold the brake pedal down. Once the pedal is down, close the
bleeder screw and release the brake pedal. Repeat the bleeding process until the brake fluid stream in the container is clear and free of air
bubbles.
d.
Repeat Steps 15a through 15c on the other brake caliper if it was replaced.
16.
Install the wheel and tire assembly. Tighten the lug nuts to 100 ft. lbs. (136 N.m).
17.
Lower the vehicle from the hoist.
18.
Verify brake fluid level and add fluid as required.
19.
Verify that there are no brake fluid leaks and that the brakes operate properly.
