Grand Cherokee 2WD V6-3.7L (2008)
6. Install the bedplate retaining bolts, making sure to place the stud bolts in the correct location, Torque the bolts in the sequence shown.
-
Hand tighten bolts 1D,1G and 1F until the bedplate contacts the block.
-
Tighten bolts 1A - 1J to 54 Nm (40 ft. lbs.)
-
Tighten bolts 1 - 8 to 7 Nm (62 in. lbs.)
-
Turn bolts 1 - 8 an additional 90°.
-
Tighten bolts A - E 27 Nm ( 20 ft. lbs.).
7. Measure crankshaft end play.
8. Install the connecting rods and measure side clearance. See: Connecting Rod/Service and Repair/Procedures/Connecting Rod Bearing Fitting
9. Install the oil pump. See: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Engine Oil Pump - Installation
10. Install the engine. See: Service and Repair/Removal and Replacement/Engine - Installation