Grand Cherokee 2WD V6-3.7L (2008)
Crankshaft: Description and Operation
DESCRIPTION
The crankshaft (1) is constructed of nodular cast iron. The crankshaft is a three throw split pin design with six counterweights for balancing purposes.
The crankshaft is supported by four select fit main bearings with the No. 2 serving as the thrust washer location. The main journals of the crankshaft are
cross drilled to improve rod bearing lubrication. The No. 6 counterweight has provisions for crankshaft position sensor target wheel mounting. The select
fit main bearing markings are located on the rear side of the target wheel (2). The crankshaft oil seals are one piece design. The front oil seal is retained
in the timing chain cover, and the rear seal is pressed in to a bore formed by the cylinder block and the bedplate assembly.
