Grand Cherokee 2WD V6-3.7L (2008)
Crankshaft Main Bearing Seal: Service and Repair
Installation
INSTALLATION
1. Lubricate the crankshaft flange with engine oil.
2. Position the Seal Installer 8349-2 (2) onto the crankshaft rear face. Then position the crankshaft rear oil seal (1) onto the guide.
3. Using the Seal Installer 8349 (2) and Universal Drive Handle C-4171 (3), with a hammer, tap the seal (1) into place. Continue to tap on the driver
handle until the seal installer seats against the cylinder block crankshaft bore.
4. Install the flexplate See: Transmission and Drivetrain/Flex Plate/Service and Repair/Installation.
5. Install the transmission.
