Grand Cherokee 2WD V6-3.7L (2008)
Front Crankshaft Seal: Service and Repair
Installation
INSTALLATION
CAUTION: To prevent severe damage to the Crankshaft, Damper or Damper Installer 8512A, thoroughly clean the damper bore and the
crankshaft nose before installing Damper.
1. Using the Seal Installer 8348 (2) and Damper Installer 8512A (3), install the crankshaft front seal.
2. Install the vibration damper. See: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper -
Installation
3. Install the radiator cooling fan and shroud. See: Cooling System/Radiator Cooling Fan/Service and Repair/Removal and Replacement/Radiator
Fan - Installation
4. Install the upper radiator hose.
5. Install A/C compressor and tighten fasteners to 54 Nm (40 ft. lbs.). See: Heating and Air Conditioning/Compressor HVAC/Service and
Repair/A/C Compressor - Installation
6. Install the accessory drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Accessory Drive Belt -
Installation
7. Refill the cooling system. See: Cooling System/Service and Repair
8. Connect the negative battery cable to battery.