Grand Cherokee 2WD V6-3.7L (2008)
HOUSING-AIR INLET
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions could result in possible personal
injury or death.
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE: LHD model shown in illustration. RHD model similar.
1. Remove the HVAC housing assembly See: HVAC Housing - Removal.
2. Disconnect the HVAC wire harness (1) from the recirculation door actuator (2).
3. Remove the three screws (3) that secure the air inlet housing (4) to HVAC housing (5).
4. Tilt the rear of the air inlet housing upward to disengage the two tab-and-slot type retainers located at the front of the inlet housing and remove the
inlet housing from the HVAC housing.
NOTE: If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.
5. If required, disassemble the air inlet housing See: Overhaul/Disassembly.
Air Inlet Housing Installation
HOUSING-AIR INLET
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE: LHD model shown in illustration. RHD model similar.
