Grand Cherokee 2WD V6-3.7L (2008)
Turn Signal Bulb: Service and Repair
Side Repeater Lamp Bulb - Removal
BULB
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Disconnect and isolate the battery negative cable.
2. Remove the repeater lamp from the fender mounting hole, but do not disconnect the wire harness connector. . See: Service and Repair/Side
Repeater Lamp - Removal
3. Firmly grasp the bulb socket (1) on the back of the lamp lens/housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb (3) straight out of the socket.
