Grand Cherokee 2WD V6-3.7L (2008)
Towing Information: Service and Repair
Towing Recommendations
STANDARD PROCEDURE - TOWING RECOMMENDATIONS
A vehicle equipped with SAE approved wheel lift type towing equipment can be used to tow WK/WH vehicles. When towing a 4WD vehicle using a
wheel lift towing device, use tow dollies under the opposite end of the vehicle. A vehicle with a flatbed device can also be used to transport a disabled
vehicle.
SAFETY PRECAUTIONS
CAUTION: The following safety precautions must be observed when towing a vehicle:
-
Secure loose and protruding parts.
-
Always use a safety chain system that is independent of the lifting and towing equipment.
-
Do not allow towing equipment to contact the disabled vehicle's fuel tank.
-
Do not allow anyone under the disabled vehicle while it is lifted by the towing device.
-
Do not allow passengers to ride in a vehicle being towed.
-
Always observe state and local laws regarding towing regulations.
-
Do not tow a vehicle in a manner that could jeopardize the safety of the operator, pedestrians or other motorists.
-
Do not attach tow chains, T-hooks, or J-hooks to a bumper, steering linkage, drive shafts or a non-reinforced frame hole.
-
Do not tow a heavily loaded vehicle. Use a flatbed device to transport a loaded vehicle.
TWO WHEEL DRIVE VEHICLE TOWING
Chrysler Corporation recommends that a vehicle be towed with the rear end lifted, whenever possible.
WARNING: When towing a disabled vehicle and the drive wheels are secured in a wheel lift or tow dollies, ensure the transmission is in the
park position (automatic transmission) or a forward drive gear (manual transmission).
WARNING: Ensure vehicle is on a level surface or the wheels are blocked to prevent vehicle from rolling.
TWO WHEEL DRIVE TOWING - REAR END LIFTED
CAUTION: Do not use steering column lock to secure steering wheel during towing operation.
2WD vehicles can be towed with the front wheels on the surface for extended distances at speeds not exceeding 48 km/h (30 mph).
1. Attach wheel lift device to rear wheels.
2. Place the transmission in neutral.
3. Raise vehicle to towing position.
4. Attach safety chains. Route chains so not to interfere with tail pipe when vehicle is lifted.
5. Turn the ignition switch to the OFF position to unlock the steering wheel.
CAUTION: Do not use steering column lock to secure steering wheel during towing operation.
6. Secure steering wheel in straight ahead position with a clamp device designed for towing.
7. Place transmission in park.
TWO WHEEL DRIVE TOWING - FRONT END LIFTED
