Grand Cherokee 2WD V6-3.7L (2008)
11.
Install the four fasteners securing the FCM to the IPM (Figure 4).
12.
Position the IPM into the vehicle.
13.
Connect the two FCM electrical connectors (Figure 3).
14.
Connect the two IPM electrical connectors (Figure 3).
15.
Position the IPM over the three bracket tabs and apply downward pressure until the retaining clips snap securely into place (Figure 2).
16.
Install the battery positive cable to the IPM B+ terminal stud.
17.
Install the IPM B+ terminal stud nut (Figure 1). Tighten the nut to 105 in. lbs. (11 N.m).
18.
Install and close the IPM cover ensuring the locking tabs snap firmly in place.
19.
Connect the negative battery cable.
20.
For vehicles that had the FCM replaced, reconfigure the FCM using the following procedure:
a.
Connect the StarSCAN to the data link connector on the vehicle and the dealership network.
b.
Turn the ignition to the "RUN" position.
c.
Power "ON" the StarSCAN.
d.
Starting at the StarSCAN "HOME" screen, select "ECU View".
e.
Select "FCMCGW Central Gateway" from the list.
f.
Select "Misc Functions".
g.
Select "Restore Vehicle Configurations" from the list and press the blue "START" button in the upper right corner of the screen.
h.
Follow the on-screen instructions to complete the reconfiguration process.
i.
Disconnect the StarSCAN from the vehicle.
