Grand Cherokee 2WD V6-3.7L (2008)
3. Reconnect the instrument panel (3) (C2) and body (4) (C1) wire harness connectors to the ORC (2) connector receptacles located on the forward
facing side of the module. Be certain that the latches and the red CPA locks on both connectors are each fully engaged.
4. Reinstall the center console onto the top of the floor panel transmission tunnel (1). See: Body and Frame/Interior Moulding /
Trim/Console/Service and Repair/Floor Console - Installation.
5. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests.
