Grand Cherokee 2WD V6-3.7L (2008)
WARNING: To avoid serious or fatal injury, use extreme care to prevent any foreign material from entering the passenger airbag, or becoming
entrapped between the passenger airbag cushion and the instrument panel top pad. Failure to observe this warning could result in occupant
injuries upon airbag deployment.
WARNING: To avoid serious or fatal injury, the instrument panel top pad must never be painted. Replacement top pads are serviced in the
original colors. Paint may change the way in which the material of the top pad responds to an airbag deployment. Failure to observe this
warning could result in occupant injuries upon airbag deployment.
NOTE: The following procedure is for replacement of an ineffective or damaged passenger airbag. If the airbag is ineffective or damaged, but
not deployed, review the recommended procedures for handling non-deployed supplemental restraints. See: Service and Repair. If the
passenger airbag has been deployed, review the recommended procedures for service after a supplemental restraint deployment before
removing the airbag from the vehicle. See: Repairs and Inspections Required After a Collision/Service and Repair.
1. Place the instrument panel top pad on a suitable work surface with the airbag retainer (1) receptacle facing up. Be certain to take the proper
precautions to prevent the top pad from receiving cosmetic damage during the following procedures.
2. Carefully position the passenger airbag housing into the airbag retainer receptacle.
3. Work around the perimeter of the unit engaging each of the hooks (2) on the passenger airbag housing through the windows in the forward and
rearward vertical walls of the retainer receptacle.
4. Reinstall the top pad onto the instrument panel.
5. Install and tighten the two screws (1) that secure the airbag mounting bracket to the instrument panel structural support (2). Tighten the screws to
12 Nm (105 in. lbs.).
6. Reconnect the passenger airbag pigtail wire connector to the instrument panel wire harness connector for the airbag. This connector is secured to
the outside of the outboard airbag unit end bracket. Be certain that the latch on the connector and the red Connector Position Assurance (CPA)
lock are each fully engaged.
7. Reinstall the instrument panel into the passenger compartment of the vehicle. See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Instrument Panel - Installation.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE
SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, See: Powertrain Management/Computers and Control
