Grand Cherokee 2WD V6-3.7L (2008)
Integrated Accessory Switch Assembly: Service and Repair
Instrument Panel Switch Pod - Removal
Lower
LOWER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel (3) from the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel - Removal.
3. Disconnect the wire harness connector from the back of the lower instrument panel switch pod (1).
4. Remove the four screws (2) that secure the switch pod to the back of the center bezel.
5. Remove the lower switch pod from the center bezel.
Upper
UPPER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel (1) from the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel - Removal.
3. Disconnect the wire harness connector from the back of the upper instrument panel switch pod (2).
4. Remove the four screws (3) that secure the switch pod to the back of the center bezel.
5. Remove the upper switch pod from the center bezel.
