Grand Cherokee 2WD V6-3.7L (2008)
Integrated Accessory Switch Assembly: Service and Repair
Instrument Panel Switch Pod - Installation
Lower
LOWER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
NOTE: There may be several different instrument panel lower switch pods available, depending upon the optional equipment content of the
vehicle. Be certain that a replacement lower switch pod matches the optional equipment of the vehicle into which it is being installed.
1. Position the lower instrument panel switch pod (1) to the back of the center bezel (3).
2. Install and tighten the four screws (2) that secure the lower switch pod to the center bezel. Tighten the screws securely.
3. Reconnect the wire harness connector to the back of the lower switch pod.
4. Reinstall the center bezel onto the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel - Installation.
5. Reconnect the battery negative cable.
Upper
UPPER
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
NOTE: There are several different instrument panel upper switch pods available, depending upon the optional or required equipment content
of the vehicle. Be certain that a replacement upper switch pod matches the optional and required equipment of the vehicle into which it is being
installed.
1. Position the upper instrument panel switch pod (2) to the back of the center bezel (1).