Grand Cherokee 2WD V6-3.7L (2008)
Solar Sensor: Service and Repair
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in an accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Using trim stick C-4755 or equivalent (1), gently pry between both sides of the sun sensor (2) and the instrument panel (3) to release the snap clip
retainers located at the front of the sensor near the windshield.
3. Carefully pull the sun sensor (2) partially out of the instrument panel (3) and disconnect the wire harness connector (1) from the sensor.
4. Remove the sun sensor from the vehicle.
