Grand Cherokee 2WD V6-3.7L (2008)
Fuel Gauge Sender: Service and Repair
Fuel Level Sending Unit / Sensor
Removal
REMOVAL
The fuel level sending unit (fuel level sensor) (3) and float assembly (7) and (8) is located on the side of the fuel pump module.
1. Remove fuel pump module from fuel tank. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and Repair/Fuel
Pump Module - Removal.
2. Disconnect electrical connector from fuel pump module. Record pin location first. Separate necessary sending unit wiring from connector using
terminal pick/removal tool.
3. To remove sending unit from pump module, use a small pick (5) or screwdriver. Lift on plastic locking tab (4) while sliding sending unit (3) down
the mounting tracks (6).
Installation
INSTALLATION
1. Noting the previously recorded pin positions, connect necessary wiring into electrical connectors, and into pump module.
2. Position sending unit (3) to pump module. Slide unit on mounting tracks (6) and snap into place.
3. Install fuel pump module. See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and Repair/Fuel Pump Module -
Installation.