Grand Cherokee 2WD V6-3.7L (2008)
Parking Brake Warning Switch: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position park brake switch (2) onto the inboard side of the park brake lever (1) bracket. Be certain to engage the locating pin on the back of the
switch insulator into the locating slot in the lever bracket.
2. Install and tighten the screw (3) that secures the switch to the lever bracket. Tighten the screw to 3 Nm (27 in. lbs.).
3. Reconnect the instrument panel wire harness connector to the terminal (4) of the switch.
4. Reinstall the console onto the floor panel transmission tunnel. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Floor
Console - Installation.
5. Reconnect the battery negative cable.
6. Turn the ignition switch to the ON position and check for proper brake indicator operation with the parking brake applied, then release the parking
brake and check that the brake indicator extinguishes.
