Grand Cherokee 2WD V6-3.7L (2008)
Combination Switch: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service.
Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing
further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental
airbag deployment.
1. Position the left multi-function switch (1) close enough to the mounting bracket integral to the left side of the clockspring (2) to reconnect the
jumper wire harness connector to the connector receptacle on the inboard side of the switch housing.
2. Align the slide tabs on the switch housing with the channel formations integral to the clockspring mounting bracket, then slide the switch into the
bracket until it is firmly seated.
3. Install and tighten the screw (3) that secures the mounting tab on the front of the left multi-function switch to the mounting bracket on the
clockspring. Tighten the screw securely.
4. Reconnect the instrument panel wire harness connector to the connector receptacle (4) on the back of the switch housing.
5. Reinstall the upper and lower shrouds onto the steering column. See: Steering and Suspension/Steering/Steering Column/Steering Column
Cover/Service and Repair/Installation.
6. Reconnect the battery negative cable.
