Grand Cherokee 2WD V6-3.7L (2008)
7. Install the hub/bearing (3), Tighten to 115 Nm (85 ft.lbs.). See: Wheel Bearing/Service and Repair/Front Hub / Bearing - Installation.
8. Install the axle shaft nut. Tighten the nut to 135 Nm (96 ft.lbs.).(if equipped with four wheel drive).
9. Install the wheel speed sensor (2) and reclip the wire to the knuckle. See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Wheel Speed Sensor/Service and Repair/Front Wheel Speed Sensor - Installation.
10. Install the disc brake rotor (1). See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Removal and
Replacement/Brake Rotor - Installation.
11. Install the caliper adapter (1). See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Disc Brake Caliper Adapter - Installation.
12. Install the tire and wheel assembly. See: Wheels and Tires/Service and Repair/Removal and Replacement.
13. Perform wheel alignment See: Alignment/Service and Repair.
